UNIKA PRO-IS2
PRO IS2 is a passive, isolated signal splitter with one input and three outputs that requires neither batteries nor phantom power. PRO IS2 is equipped with a pair of UNiKA-PRO EI9AE3R3 1.25:1 isolation transformers with special coating surrounded by a shield of oriental silicon steel with a special copper foil layer and a proprietary grounding layer. This achieves a high signal-to-noise ratio and a dynamic sound and avoids unnecessary interference from high-frequency noise, ground loops and potential differences. PRO IS2 is particularly suitable for recording studios, live performances and fixed installations.
The input of the PRO IS2 is equipped with combo jacks for balanced XLR and TRS connectors. The CH-1/CH-2 output channels are each equipped with an independent UNiKAPRO isolation transformer and a independent GND/LIFT switch to avoid interference caused by potential differences and ground loops.
FEATURES
- CIRCUIT PRINCIPLE: Passive with transformer-balanced output
- INPUT: 2 x combo jacks
- INPUT IMPEDANCE: 4.7KΩ balanced/10KΩ unbalanced
- OUTPUT IMPEDANCE:600Ω
- MAX. INPUT LEVEL BEFORE CLIPPING: +22dB
- MAX. OUTPUT LEVEL: +22 dB
- OUTPUT GND/LIFT SWITCH: Independent push button for each channel
- FREQUENCY RATE: 20Hz-20KHz, -0.3/+0.1dB
- S/N RATIO @20HZ~20KHZ UNWEIGHTED: >120dB
- T.H.D.@1KHZ 0DBV OUTPUT: <0.02%
- TRANSMISSION RATIO: 1.25:1
- HUSING: 1.6mm/1.2mm steel case and chassis
- SURFACE FINISH: Durable complex painting
- DIMENSIONS (W X D X H): 78 x 124 x 46 mm
- WEIGHT: 0.62kg
The CH-2 is equipped with a switch button. If the hot pin of the cable is pin 3, this button can be used to switch the hot pin to pin 2. Each output has a independent GND/LIFT switch, which can be used to ground or unground pin 1 of the output to avoid noise or losses in case of ground loops or unintended ground loops.
UNIKA
PRO-IS2
PASSIVE ISOLATED SIGNAL SPLITTER
UNIKA
PRO-IS2
PASSIVE ISOLATED SIGNAL SPLITTER